Mini Tracker Receiver added 2
We have just added a simplified low-cost receiver. This works as well as the other receivers but with fewer additional features and at a lower cost. See the product item: HERE See the tracker receiver support page: HERE
receiver
Modifying FPV system for NZ 5.8GHz ISM band compliance
Hobbyking 5.8GHz 200mW FPV system The “Boscam 5.8Ghz 200mw FPV Wireless AV Tx & Rx Set” from Hobbyking is a great low cost system but is not compliant with the 5.8GHz ISM band here in New Zealand. The 8 channel frequencies listed by Hobbyking are 5705 5865 5665 5645 5885 […]
Servo PPM Buffer Level Converter product added
Product added here. This is a in-line PPM buffer or level converter. It normally connects between the RC receiver and whatever it’s controlling, servo, auto-pilot, LED controller etc. Many modern receivers operate at lower voltages and output PPM signals of 3V or less. Sometimes this low level PPM signal must […]
Tripod mount for FPV Receivers
I have built a mount for the recently rewired FPV receivers. It’s made out of pine, glued, screwed and painted. It mounts directly to the quick release on the small tripod. See this post for details of the RC305 receiver mods.
RC305 AV Receiver Mods
Introduction I use two RC305 receivers connected to a diversity controller in my FPV ground station. This was connected using a cable of about 1.5 meters with 4 RCA connectors and a few DC power connectors. After a while the RCA connector become loose and I don’t trust them. So […]
