PMB-NZ – rcbeacon.com

RC & Electronics

Daily Archives: October 5, 2012

Raspberry-Pi direct 5V power wiring modification 5

October 5, 2012 in Computers tagged direct / modification / power / raspberry-pi / solder / soldered by PMB

To feed power directly to the Raspberry-Pi board without using the micro-USB connector, I soldered 2 wires directly to the back of the circuit board. The connection leaves the fuse and reverse-polarity protection diode in circuit. A couple of small holes drilled into the side of the case to form […]

Raspberry Pi direct power wiring modification

RC LED Flasher Controller updated

October 5, 2012 in RC Planes tagged controller / flasher / led / rc by PMB

I have recently updated the RC LED flasher controller to simplify the flash pattern programming slightly. Originally you needed a LED connected to channel 6 to indicate the pattern count. The small on-board status LED now provides the indication as well as channel 6; which is still useful when the […]